Husqvarna AUTOMOWER Operator's Manual page 19

Do not position the charging station so that the mower
can come closer than 10 ft behind the charging
station (for example on a narrow point). It will then be
harder for the mower to find the charging station.
Installation and connecting the charging
station
1. Position the charging station in a suitable spot.
2. Secure the charging station to the ground using
the supplied nails.
IMPORTANT INFORMATION
It is not permitted to make new holes in the
plate. Only the existing holes may be used to
secure the plate to the ground.
3. Connect the low voltage cable to the charging
station.
Only use original cable and transformer.
4. Connect the low voltage cable to the transformer.
The connectors may be slightly difficult to
connect, as they are moisture-proof.
5. Connect the transformer's power cord to a 120 V
wall socket. It is preferable to use an earth-fault
breaker as recommended.
20 - English
3. INSTALLATION
3012-822
3012-549
3012-263
3012-262