Husqvarna AUTOMOWER Operator's Manual page 18

Consider the distance to a wall socket when choosing
the position. The charging station should be
connected to a 120V wall socket via the low voltage
cable and transformer.
The supplied low voltage cable is 66 ft long.
Tip!
It is possible to let the low voltage cable cross
the working area. It must then be either stapled down
or buried. In some cases there is a better positioning
option for the charging station than close to a house
wall or by the closest wall socket.
IMPORTANT INFORMATION
The low voltage cable must not be extended.
IMPORTANT INFORMATION
The transformer is for indoor use only.
The transformer must be placed where it is well
ventilated and is not exposed to direct sunlight.
IMPORTANT INFORMATION
The power cord on the transformer must not
be replaced. In those cases where the power
cord has been damaged, the transformer
must be discarded and replaced by a new
one.
It is recommended to use an earth fault-breaker when
connecting the transformer to the wall socket.
Do not put the charging station in a corner or pocket
in the working area.
Avoid placing the charging station in a narrow
passage (narrower than about 10 ft).
3. INSTALLATION
3012-220
3012-223
3012-513
3012-514
3012-515
English - 19