Installation Of The Charging Station - Husqvarna AUTOMOWER Operator's Manual

• Transformer (19)
• Low voltage cable (20)
• Staples (21)
• Connector for the loop wire (22)
• Nails (23)
• Measurement gauge (24)
• Solderless coupler for the loop wire (25)
During installation you will also need: A hammer to
knock the staples into the ground, combination pliers,
and a straight spade if the boundary wire is to be
buried.
3.2 Installation of the charging
station
Ideal position of the charging station
For examples of good positioning of the charging
station, see 7. Garden example on page 63.
If you are going to install a guide wire, read 3.8
Installation of the guide wire, see page 32, before
choosing the position of the charging station.
The charging station must be positioned with a great
deal of free area in front of it (at least 10 ft). It should
also be positioned centrally in the working area so
that Automower can easily find the charging station
and quickly reach all parts of the working area.
It is a good idea to place the charging station in the
shadow. The battery is spared if it is charged in the
lowest possible ambient temperature.
The charging station must be positioned on relatively
level ground. The height difference must not differ
more than 2" between the front and rear of the
charging station.
The charging station must not be positioned so that
its plate bends.
18 - English
3. INSTALLATION
3012-510
3012-554US
3012-532