Optional Wall Switch Or Thermostat Installation - Travis Industries 864 HO Installation Manual

Optional Wall Switch or Thermostat Installation

Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The switch and
wiring must be installed by a qualified installer.
This fireplace includes an optional wall switch (with wire) to operate
the fireplace burner without accessing the internal on/off switch. A
thermostat may be used instead. Route the wire from inside the
fireplace, through the grommet on either side of the fireplace near the
gas inlet (see illustration to the right) to the switch. The wall switch
(or thermostat) may bypass the fireplace on/off switch or be installed
in parallel or series configuration (see below).
Caution: Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and
dangerous operation.
Note: When using a GreenSmart™ remote, use the receiver for on/off operation (do not use a wall
switch or thermostat).
Warning: Make sure all wiring is secure and does not contact hot or moving components.
Parallel Connection
Thermostat/External Switch ON
Thermostat/External Switch OFF
To wire the heater in parallel, follow the directions below:
Series Connection
Thermostat/External Switch ON
Thermostat/External Switch OFF
To wire the heater in series, follow the directions below:
© Travis Industries
Installation
(for qualified installers only)
On/Off Switch ON
Heater is ON
Heater is ON
On/Off Switch ON
Heater is ON
Heater is OFF
4100728
On/Off Switch OFF
Heater is ON
Heater is OFF
On/Off Switch OFF
Heater is OFF
Heater is OFF
100-01254_000
17