Step 5. Remove LVS Temperature Sensor PCB by following
Step 6. Disconnect the following wiring connections:
Step 7. As shown in
Step 8. Remove LVS. Note fish paper (Wire Shield) under LVS, save and reuse with
Step 9. Replace by performing steps 3 through 7 in reverse order.
02. 96 85. 001 0 A
Temperature PCB Replacement (VL500 80V Only)" on page 56
a. 3-position connector (AC Input)
b. 6-position MTA connector (DC Output)
Figure 27
replacement LVS.
21-May-2009
, remove four 4-40x1/4" PPZ screws.
M
:
AINTENANCE
"Low Voltage Supply (LVS)
.
2
55