80V Dimmer Replacement - Vl500 80V Only - Philips VL500 Wash Luminaires Service Manual

80V Dimmer Replacement - VL500 80V Only

Parts:
21.9685.2750
Tools:
• #2 Phillips Screwdriver
WARNING:
To remove and replace 80V dimmer:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke cover on dimmer side by removing four 6-32x3/8" LG PTB screws.
Step 3. As shown in
Step 4. Carefully remove 80V dimmer. Note that there will be wires connected to dimmer
CAUTION:
both the AC Line Input and Load (Output) terminals on the IGBT dimmer with a black marker
before removing so the phasing can be maintained.
Step 5. At dimmer, carefully note (and label before removing) and disconnect following
Step 6. Remove four 6-32x3/8" PPZ screws from Step 3. Install these screws in replacement
WARNING:
contact with dimmer; they may damage components on dimmer.
02. 96 85. 001 0 A
1 EA ASSY, 80V DIMMER
Remove power from luminaire before performing maintenance.
Figure 34
, at dimmer, loosen, but do not remove, four 6-32x3/8" PPZ
screws.
on the back side.
All AC wiring is same color. It is a good idea to mark the connector attached to
wiring:
a. 4-position (Dimmer Communication from MCB)
b. Four Faston (Quick Connects - AC Input / lamp Power Output)
c. Ground Wires
80V dimmer.
Be careful with ferrite cores on lamp wires. Make sure they do not come in
21-May-2009
2
M :
AINTENANCE
65