Philips VL500 Wash Luminaires Service Manual page 56

VARI❋LITE® - VL500™ L
Color Filter and Diffuser Panel Removal (contin-
ued)
Step 6. Disconnect actuator screw from Swivel Coupler using tweaker screwdriver by
Color Filter/
Diffuser Panel
Step 7. Open glass filter or diffuser panels.
Step 8. Remove filter or panel as follows (shown in
Step 9. Insert filter carrier pin (of replacement filter or panel) into center hub as shown in
Step 10. Place side of silicone pad with lip into arch on installed carrier.
Step 11. Using tweaker screwdriver, gently run screwdriver tip over silicone pad, driving
Step 12. Reassemble luminaire.
38
S
UMINAIRE ERVICE
carefully prying apart from Drive Ring Link.
Insert Filter
Carrier Pin
Center Hub
Figure 12: Color Filter and Diffuser Panel Removal
a. At filter or panel, gently push assembly (with silicon pad) in towards center hub
(away from carrier) and work end of tweaker screwdriver between silicon pad
and carrier.
b. Gently work side of silicone pad (not under carrier arch) free.
c. After side of silicone pad is free from carrier, remove silicone pad from under
carrier arch and remove filter or panel.
Figure 12
.
silicone pad into carrier and fully seating silicone pad.
21-May-2009
M
ANUAL
Silicone Pad
Bulkhead
Figure 12
Pad Lip
Filter Carrier
Carrier Arch
):
02 .9 685 .00 10 A