Storage; Moving About - Drive Medical GLADIATOR GT807 Owner's Manual

6 . I N S P E C T I O N A N D M A I N T E N A N C E
Suggestion
Ask for help from your scooter dealer to inspect or replace the fuse, since the tiller shroud has to be
removed first before you can replace the fuse.
Tires
The condition of the tires depends on how you drive and use your scooter.
Inspecting tires tread
Please check the tread depth regularly. Replace the tires when the tread depth is less than 0.5 mm.
Attention
. When tread depth is below 0.5mm it can easily lead to vehicle slippage, making braking
distances longer. Therefore replace the tires as early as possible when they do not have
insufficient tread depth.
. The tire pressure shall be kept at about 26 PSI (approx. 1.8KG/cm) for the best ride and
handling.
Attention
When conducting maintenance of your vehicle, please turn the power switch to OFF and remove the
charger cords.
Suggestions
Do not splash water directly to wash your scooter as this could lead to malfunction of the system
electrics.
Do not use gasoline, solvents or vaporizing solution as these may deform or damage the shrouds.
Do not use wax.

6.4 STORAGE

Make sure the vehicle is stored under the following conditions:
- Make sure the seat is set in the "Forward position
- Make sure the Power switch is turned to OFF
Suggestion
Please store the scooter in a location where it is away from the direct sunlight, rain, or dew. When
storing for a long time, please charge the battery to full power and then disconnect the battery
terminal. For details inquire to your scooter dealer.

6.5 MOVING ABOUT

Turn the power switch "OFF" before moving.
Lift the scooter by the chassis, and not by the bumpers. Lifting the scooters by the bumper could
cause damage or injury.
For your safety, always ask for help if required. You will need 2 or 3 persons when moving or
lifting
the vehicle.