Drive Medical GLADIATOR GT807 Owner's Manual page 15

5 . B AT T E R Y C H A R G I N G A N D C A R E
1. Turn the scooter power switch to "OFF".
2. Remove the seat and dust cover.
3. Remove the shroud and unplug the terminal of the taillight and signal lights.
4. Use a clean cloth to wipe off the soiled area.
5. Take out the battery.
6. Clean the battery with a clean cloth. If the terminal is covered by white powder, wipe it
clean using warm water.
Charger replacement
1. Follow procedure 1 and 2 above.
2. Turn the battery up as photo showed in right.
3. Remember how the wire and socket are situated in the battery pack before you move the charger's
wire and socket.
4. Unplug the socket to remove the charger, then replace a new one.
5. Locate the wire, socket and LED on the battery pack.
6. Following procedure 7 above.
Warning
1. The wiring system and charger are well situated in the battery pack while assembled in the plant.
Do not attempt to re-locate the wiring system by yourself. The improper layout of wiring system
may result in the wires pinched by battery box, which might result in electronic system failure.
2. Be sure the battery wires are connected to their right battery terminal.
Suggestions
If necessary, ask for help from your dealer for advice about maintaining and replacing the battery.
Suggestions
1. Make sure the terminals are installed properly and put the cover back on.
2. Do not use the battery to charge communication equipment or other items.
3. Battery efficiency will vary with outside conditions; the driving distances will be shorter in the
winter. If the vehicle is not used for a long time, please charge the battery at least every week.
4. Replace both batteries together.