Listening To Fm/Am Radio; Setting The Frequency Steps; Selecting A Frequency For Reception - Yamaha RX-V577 Owner's Manual

TRANSMIT TRANSMIT
RECEIVER RECEIVER
SLEEP SLEEP
You can tune into a radio station by specifying its frequency or
HDMI HDMI
1 1 2 2 3 3 4 4
selecting from registered radio stations.
5 5 6 6
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 • The radio frequencies differ depending on the country or region where the unit is
ZONE A ZONE A
FM
AUX AUX USB USB NET NET ZONE B ZONE B
AM
FM AM
• If you cannot obtain good reception on the radio, adjust the direction of the FM/AM
TUNING
PRESET PRESET TUNING
INFO INFO MEMORY MEMORY
MOVIE MOVIE MUSIC SUR. DECODE STRAIGHT MUSIC SUR. DECODE STRAIGHT

Setting the frequency steps

BASS BASS ENHANCER ENHANCER DIRECT DIRECT
SCENE SCENE
BD BD
TV TV NET NET RADIO RADIO
DVD DVD
(Asia and General models only)
SETUP SETUP OPTION OPTION
At the factory, the frequency step setting is set to 50 kHz for FM and
9 kHz for AM. Depending on your country or region, set the
ENTER ENTER VOLUME VOLUME
frequency steps to 100 kHz for FM and 10 kHz for AM.
RETURN RETURN DISPLAY DISPLAY
1
TOP TOP POP-UP POP-UP
MUTE MUTE
MENU MENU MENU MENU
MODE
MODE
2
3
4
5

Listening to FM/AM radio

being used. The explanation of this section uses a display with frequencies used
in U.K. and Europe models.
antennas.
Set the unit to standby mode.
When holding down STRAIGHT on the front panel,
press z (power).
z (power)
PROGRAM STRAIGHT
Press PROGRAM repeatedly to select "TU".
SLEEP MUTE
CHARGE ENHANCER STEREO TUNED
OUT VOL.
ECO
TU••••FM50/AM9
Press STRAIGHT to select "FM100/AM10".
Press z (power) to set the unit to standby mode
and turn it on again.

Selecting a frequency for reception

1
Press FM or AM to select a band.
"TUNER" is selected as the input source and then the
frequency currently selected is displayed.
CHARGE
OUT
ECO
2
Press TUNING repeatedly to set a frequency.
Hold down the key for about a second to search stations
automatically.
CHARGE
OUT
ECO
"TUNED" lights up when a signal is received from a radio
station.
"STEREO" also lights up when a stereo signal is received.
• You can switch between "Stereo" (stereo) and "Mono" (monaural) for FM
radio reception by pressing MODE. When the signal reception for an FM
radio station is unstable, switching to monaural may improve it.
• You can watch videos input from external devices while listening to radio by
selecting the video input jack in "Video Out" (p.75) in the "Option" menu.
ADAPTIVE DRC VIRTUAL
ENHANCER STEREO TUNED SLEEP MUTE
VOL.
FM 87.50MHz VIRTUAL
ADAPTIVE DRC
ENHANCER STEREO TUNED SLEEP MUTE
VOL.
FM 98.50MHz ADAPTIVE DRC VIRTUAL
PLAYBACK ➤ Listening to FM/AM radio
49
En