Error
757
Load Supplies
758
Check Supply
762
Low Battery
763
Remove Label
765
Check
Printhead
768
Check
Printhead
791
Error Pending
If you see a System Error Vector ## on the display,
call Technical Support for instructions. If you need to
return the printer to Paxar, use the original packaging
(box and packing material).
4-4 Troubleshooting
Description
Load supplies (supply length mismatch),
because the calibrated supply length
differs by plus or minus .25 inches from
the format. Press the A button under
the x icon to clear the error.
Either the supply is not seen or the on-
demand sensor is broken. Press the A
button under the x icon to clear the error.
Check for a label jam, clear the supply
path, or reload supplies. This error may
occur if you remove a label too quickly in
on-demand mode. The printer does not
recalibrate after this error.
Recharge the battery. Press the A
button under the x icon to clear the error.
Waiting to dispense label. Press the A
button under the x icon to clear the error.
The printhead has less than four bad
dots. The printer can shift bar code
fields to avoid bad dots. Press the A
button under the x icon to clear the error
and continue printing.
Printhead has more than 10 bad dots or
is not connected. Connect the printhead.
Press the A button under the x icon to
clear the error.
The printer has an error pending. Turn
off the printer. Wait 15 seconds and turn
it back on. Resend the packets.