Paxar Monarch Sierra Sport 2 9460 Operator's Handbook Manual page 19

The supply should unwind as shown
4. Pull out enough supply to lay across the exit chute
and raise the supply door back to the upright
position (as shown below).
5. Remove a couple of labels from the liner. Feed
the supply under the peel bar.
Release
Button
The peel bar should be open. If not,
located on both sides of the printer.
with the loose end of the supply
feeding through the exit chute.
push up on the release buttons
Exit Chute
Peel Bar
Loading Supplies 2-5