Advertisement
9. Strip 1/4" of insulation from the end of
each wire coming from the amplifier.
10. Tightly twist the end of each wire until
no frayed ends remain.
11. Attach the speaker wires to the speaker
terminal connectors. Connect the
negative output from the amplifier to the
black terminal and the positive output to
the red terminal.
12. There are four clamps "dogs" which
hold each speaker in place. Rotate all
the dogs inward.
13. Insert the loudspeaker into the cutout in
the ceiling.
14. The dogs are tightened via four
front-baffle screws. Tighten the dogs
by turning the screws clockwise,
while pressing the loudspeaker against
the ceiling. NOTE: DO NOT OVER
TIGHTEN THESE SCREWS. Over-
tightening the screws may make the
grille difficult to install.
15. Install the grille into the speaker.
16. Repeat this procedure for the next
speaker.
Installation New Construction:
Install the proper ceiling bracket for this
loudspeaker (NCB-5) using the instructions
supplied with the bracket. After the hole is
cut in the drywall per the bracket
instructions, perform the following steps:
1. Strip 1/4" of insulation from the end of
each wire coming from the amplifier.
2. Tightly twist the end of each wire until no
frayed ends remain.
3. Attach the speaker wires to the speaker
terminal connectors. Connect the
negative output from the amplifier to the
black terminal and the positive output
from the amplifier to the red terminal.
4. There are four clamps "dogs" which
hold each speaker in place. Rotate all
the dogs inward.
5. Insert the loudspeaker into the cutout in
the ceiling.
6. The dogs are tightened via four
front-baffle screws. Tighten the dogs
by turning the screws clockwise,
while pressing the loudspeaker against
the ceiling. NOTE: DO NOT OVER
TIGHTEN THESE SCREWS. Over-
tightening the screws may make the
grille difficult to install.
7. Install the grille into the speaker.
8. Repeat this procedure for the next
speaker.
Removing the Grilles:
To remove the grille from the LSC-5, obtain a
small paper clip (size #1, common) and bend
the last quarter inch of it into an "L" shape.
Holding the paper clip with a pair of pliers,
insert the end with the "L" into a hole near
the edge of the grille. Remove the grille by
pulling the paper clip towards you.
For the LSC-5R, press your fingers against
the inside of the grille's white collar.
While pressing against the collar, pull it
towards you.
3
Advertisement
