Connection terminals accepts up to 12 gauge speaker wire Quick mounting system for new construction or retrofit Includes hole template and paint mask Ceiling Bracket for New Construction: Jobsite NCB-6 (sold separately) PRODUCT OVERVIEW The illustration shows how a typical JobSite LSC loudspeaker mounts into a ceiling.
Speaker grille x 1 Speaker hole template / paint mask x 1 PREPARING FOR INSTALLATION If you are installing the LSC-6S into an existing ceiling, take time to consider any possible obstructions which may be hidden inside the ceiling: ceiling joists, electrical wiring, telephone wiring, plumbing, AC or heating conduit and ductwork.
Page 5
8. Install the grille into the speaker. Removing the Grilles: To remove the grille from the LSC-6S, obtain a small paper clip (size #1, common) and bend the last quarter inch of it into an “L” shape. Holding the paper clip with a pair of pliers, insert the end with the “L”...
Painting the Grilles The LSC-6S grille should be painted before it is installed on the speaker. The best results will be obtained by using a spray gun or airless sprayer. Thin the paint, and then apply several light coats. This technique helps prevent clogging of grille holes.
If the above conditions are met, the purchaser’s sole remedy shall be to return the product to JOBSITE, in which case JOBSITE will repair or replace, at its sole option, the defective product without charge for parts or labor. JOBSITE will...