Resetting The Switch - Symbol ES3000 Manual

2-8 ES3000 Advanced Concept Guide
Set TFTP [S]erver IP Address
Set Image [F]ile Name
[U]pgrade Image
[Q]uit to previous menu
Command>
Enter "S" to set the server IP number to the IP number for the TFTP server. Enter "F" to set the runtime
software filename. Enter "U" to install the new runtime software image. The runtime software will
download and install and the switch will reboot. This process may take several minutes to complete.

2.5 Resetting the Switch

If the password to the switch if lost or forgotten, the switch may be reset to the factory defaults,
including the default password of "symbol" by the following:
1. Establish serial communication with the switch
2. Power cycle the switch
3. During the boot cycle repeatedly enter Escape (esc) characters
4. When the system asks "
with "Y"
During this procedure, the screen in communication with the switch will look like:
Memory test......OK
System database initialization ... OK
PCI unit 0: Dev 0x5645, Rev 0x11, Chip BCM5645_B0, Driver BCM5615_A0
Attaching SOC unit 0... PCI device BCM5645_B0 attached as unit 0.
BCM register test ............ PASS
PHY register test ............ PASS
Internal MAC loopback test ... PASS
Checking Image Bank Integrity ... OK
Booting system ...
Decompressing...OK
Press 'ESC' key to reset to factory default ...
Reset configuration to factory default (y/n)?
" answer