Bootcode And Bootcode Prompt - Symbol ES3000 Manual

Spanning [T]ree ...
Qo[S] ...
[E]xecute CLI
[Q]uit
Command>
Select "A" for "System Admin", then "A" for "Access" and "I" for "IP Config."
The following screen will display:
Access -> System IP Configuration Menu
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
DHCP Mode:
---------------------------- <COMMAND> ------------------------------
Set [I]P Address
Set Subnet [M]ask
Set Default [G]ateway
Set [D]HCP Status
Set DHCP [R]enew
[Q]uit to previous menu
Disable DHCP, and set the IP address, subnet mask, and default gateway. Communication using the
specified IP address should now be possible.
Unless the switch configuration is saved, the IP address will remain functional only until the switch
reboots. To save the switch configuration, quit out to the main menu, enter "A" for "System
Admin.","T" for "Tools", and "S" for "Save Config". The switch will save the IP address along with
other configuration parameters in flash memory.

2.3 Bootcode and Bootcode Prompt

The software on the ES3000 switch is in two parts: the bootcode and the runtime code. The bootcode
can only be updated through the serial interface to the switch.
00:30:AB:25:81:31
192.168.2.50
255.255.255.0
192.168.2.1
Disabled
ES3000 Software Management
2-3