Hardware Installation - Vivotek FD7130 User Manual

Hardware Installation

First, use the supplied screwdriver to detach the dome cover from the camera base� Insert your
MicroSD/SDHC Card if necessary�
Tamper-proof screw
Then, follow the steps below to install the camera to either the ceiling or the wall:
1� Attach the supplied alignment sticker to the ceiling/wall�
2� Using the 3 screw circles on the sticker, drill 3 pilot holes into the ceiling/wall� Then hammer
the plastic anchors into the holes�
3� This Network Camera can be mounted with the cable routed through the camera base or
from the side of the dome cover� If you want to feed the cable through the ceiling/wall, please
also cut or drill a hole (A) for the cable� If the cable goes through the side of the dome cover,
please remove the rubber stopper (B)�
4� Through the 3 holes on the camera base, insert the screws to corresponding holes and se-
cure the camera base with a screwdriver�
Ceiling Mount
1 2
Camera Base
A
3
A
B
VIVOTEK
Dome Cover
Rubber Stopper
4
User's Manual - 7