Gpo; Gpo Time - D&R AXUM User Manual

A·X·U·M User Manual
or 1). A value of '1' makes sure that if the GPI is +5V the function is made active. The value '0'
makes sure that if the GPI is 0V the function is made active.
When you submit an empty box the object returns to the startup default value.
9.3.3

GPO

Figure 43: GPO configuration
•
Default
The gray value is the startup default, this may be changed by assigning a custom value(0 or
1). A value of '1' makes sure the GPO is active at startup. A value of '0' makes sure the GPO
is inactive at startup. The GPO output state is also depending on the GPO active-state setting.
When you submit an empty box the object returns to the startup default value.
•
Function
Here you may select which engine function is connected to the object. To use the GPO
functions you should maybe change the hardware jumper setting on the board (see chapter
11.3.1 GPIO TTL/Relay selection) to enable the given engine function The default jumper
setting is GPO-Relay for all cards except for the MIC input card. The default jumper setting for
the MIC input card is GPIO-TTL for GPIO 1, 3, 5 and 7 and GPO-Relay for GPIO 2, 4, 6 and
8.
9.3.4

GPO Time

Figure 44: GPO Time configuration
•
Default
The gray value is the startup default, this may be changed by assigning a custom value.
AXUM from D&R - Phone: +31 294 418014 - E-Mail:
Version 2.5 - 2011-01-28
info@d-r.nl - 66 -