Turning On The Av Receiver/Av Amplifier; Turning On And Standby - Onkyo TX-SR705 Instruction Manual

Turning On the AV Receiver/AV Amplifier

STANDBY/ON
STANDBY indicator

Turning On and Standby

1
AV receiver/
AV amplifier
or
Smooth Operation in a Few Easy Steps
To ensure smooth operation, here's a few easy steps to help you configure the AV receiver/AV amplifier before you
use it for the very first time. These settings only need to be made once.
■ Do the automatic speaker setup—this is essential!
See "Automatic Speaker Setup (Audyssey MultEQ XT)" on page 54.
■ Have you connected a component to an HDMI input,
component video input, or digital audio input?
If you have, see "HDMI Input Setup" on page 48, "Component Video
Setup" on page 49, or "Digital Input Setup" on page 51 respectively.
■ Have you connected an Onkyo MD recorder, CD recorder,
or RI Dock?
If you have, see "Changing the Input Display" on page 50.
44
Press the [STANDBY/ON] button.
Alternatively, press the remote controller's [RECEIVER] button, followed
Remote
controller
by the [ON] button.
The AV receiver/AV amplifier comes on, the display lights up, and the STANDBY
indicator goes off.
Pressing the remote controller's [ON] button again will turn on any components con-
nected via
To turn the AV receiver/AV amplifier off, press the [STANDBY/ON] button, or press
the remote controller's [STANDBY] button. The AV receiver/AV amplifier will enter
Standby mode. To prevent any loud surprises when you turn on the AV receiver/AV
amplifier, always turn down the volume before you turn it off.
STANDBY
RECEIVER
.
ON
HDMI
OUT IN
CD recorder, MD recorder,
TAPE
RI Dock