Table of Contents
Advertisement
To program the throttle stick position select the menu screen,
and then press the "radio" submenu to get to the adjust screen.
This first menu is only informative and it warns you of the
entrance into the screens of programming of the throttle
control. Press the button 'Data Up' to enter in the programming
menus. Next the screen of programming the full throttle
position is displayed.
In order to program these parameters locate the trim and stick
in the maximum position. Once located in this position, push
the button "Data Up". At this moment the POWERPACK / ECU
will record this as the position of full power.
The following screen allows programming the lower limit
(Stop). In order to do this, locate the trim and stick to the
minimum position and push the button "Data Up".
The last screen is the position of the trim that will correspond to
the idle of the turbine. To make this adjustment locate the stick
to the minimum position and the trim to the maximum position
then push the button "Data Up".
Note: When in the transmitter adjustment menu and changes
to transmitter adjustment are not required pushing the "Menu
up" button will cause the screen to change without varying the
previous adjustment.
Once the programming of the transmitter is finished it can be
verified by means of the secondary screen of the HDT.
23
Advertisement
Table of Contents
