Table of Contents
Advertisement
4.6 Info Submenu
When this option is selected, the first screen will show the first avaliable timer.
The next six options are test options. For access to these options you must have the trim
down on your transmitter. They all have an ON (-) / OFF (+) button and you can test them
individually: the Starter, Glow Plug, Fuel Pump, Gas Valve and Fuel Valve.
"Timer service:" – The total time in minutes that your turbine
has run since last service
"Last:"- The time in seconds of your last run
"Cy:" – The number of cycles (start, run, off) your turbine has
The next screen lists dropped pulses, the total time duration
of the lost signal and the RX voltage
In the next screen is the "Tot. Time:" this timer is the total run
time of your turbine since it was manufactured
Below are the turbine serial number and the software version
20
Advertisement
Table of Contents
