Table of Contents
Advertisement
Slide-in Labels
Appendix C
The spare slide-in labels on the following pages are provided for the MS-2410BC keypad and display panel in the
event that the original labels are lost or damaged. The labels may be cut from the manual or photo-copied and then
carefully cut out and inserted into the proper location, as indicated in Figure C-1. Labels slide into pockets which are
accessible through the top of the keypad and display panel.
During the Normal Mode of operation, insert the labels into the keypad and display panel as follows (refer to Figure
C-1):
• Label A Normal Mode label into pocket designated Label A
• Label B Normal Mode label into pocket designated Label B
• Label C Normal Mode label into pocket designated Label C
During Program Mode of operation, insert the labels into the keypad and display panel as follows:
• Label A Program Mode label into pocket designated Label A
• Label C Program Mode label into pocket designated Label C
A set of English labels is provided for Normal Mode operation and another set is provided for Program Mode
operation. In addition, a set of French labels is provided for Normal and Program Mode operation. Be sure to insert
the proper set of labels for the corresponding mode of operation. Figure C-1 illustrates Normal Mode English labels
installed in the keypad and display panel. Note that extra 'A' Normal Mode slide-in labels are also supplied blank.
Type the desired zone or location information directly on the line inscribed on the labels to insure correct positioning
of the typed information in the label windows. Information should be typed before cutting the labels from the page.
Keypad and Display Panel Slide-in Labels
FIGURE C-1:
Slide-in Labels
Label A
Label B
Document #50801
Label C
Rev. B
8/17/98
P/N 50801:B
55
Advertisement
Table of Contents
