Unlocking The Sfp Module Latch - Plastic Variety; Unlocking The Sfp Module Latch - Wire Variety - IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual

Plastic tab
Protective cap
o
10
Figure 99. Unlocking the SFP module latch - plastic variety
v For SFP modules that contain wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 23 on page 36.
Wire
tab
Protective
cap
o
90
Figure 100. Unlocking the SFP module latch - wire variety
c. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
5. Remove the failed RAID controller (the Fault LED is on), as follows:
a. Push down on the latch (centered above the RAID controller). Pull both
levers at the same time out of the locked position.
SFP module
SFP
module
Chapter 5. Installing and replacing components
137