IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual page 171

CAUTION:
This product contains a sealed lead acid battery. The battery must be
recycled or disposed of properly. In the United States, IBM has
established a collection process for reuse, recycling, or proper disposal
of used IBM sealed lead acid batteries. For information on proper
disposal of these batteries, please contact IBM at 1-800-426-4333 your
IBM representative. For information on disposal of sealed lead acid
batteries outside the United States, go towww.ibm.com/ibm/environment/
products/batteryrecycle.shtml or contact your local waste disposal
facility. If the battery CRU is physically damaged or leaking electrolyte
gel, do not ship it to a recycling center. The battery contains sealed
lead-acid batteries that might be considered hazardous material. You
must handle this unit in accordance with all applicable local and federal
regulations.
15. Position the replacement battery inside the RAID controller.
16. Reassemble the battery access panel to the RAID controller bottom panel by
aligning it with the three pins on the RAID controller bottom panel. Slide the
battery access panel toward the back until you can reinsert the screw that
holds the battery access panel to the RAID controller bottom panel. Do not
overtighten
17. You must reconnect the battery harness to the two-pin connector on the
controller board.
Note: The connector is keyed so that there is only one way to attach the
hardness to the connector. Do not force fit.
18. Flip the RAID controller bottom panel over and carefully place it on the
controller sides. Push the RAID controller bottom panel toward the front to
latch it to the side panels. If the controller bottom panel is placed correctly, you
should be able to access the mounting holes for the six screws that you
removed in step 6 on page 138. Reinsert the six screws. Do not overtighten.
19. [NTD]: This information is stated in the Caution above. Does it need to be
said again? Seems redundant. Dispose of the used battery CRU according
to local and federal regulations, which might include hazardous material
handling procedures.
This product contains a sealed lead acid battery. The battery must be recycled
or disposed of properly. In the United States, IBM has established a collection
process for reuse, recycling, or proper disposal of used IBM sealed lead acid
batteries. For information on proper disposal of these batteries, please contact
IBM at 1-800-426-4333 your IBM representative. For information on disposal of
sealed lead acid batteries outside the United States, go to
www.ibm.com/ibm/environment/products/batteryrecycle.shtml or contact your
local waste disposal facility.
20. Install the RAID controller, as shown in Figure 104 on page 144.
Chapter 5. Installing and replacing components
143