Unlocking The Sfp Module Latch - Plastic Variety; Unlocking The Sfp Module Latch - Wire Variety - IBM TotalStorage DS4300 Installation, User's, And Maintenance Manual

Protective cap
Figure 85. Unlocking the SFP module latch - plastic variety
Protective
Figure 86. Unlocking the SFP module latch - wire variety
11. Remove each RAID controller to be upgraded, as follows:
118
IBM TotalStorage DS4300 Fibre Channel Storage Subsystem: Installation, User's, and Maintenance Guide
Plastic tab
o
10
v For SFP modules that contain wire tabs, unlock the SFP module latch by
pulling the wire latch outward 90°, as shown in Figure 86.
Wire
tab
cap
o
90
module
c. With the SFP latch in the unlocked position, extract the SFP module.
v For SFP modules that contain plastic tabs, slide the SFP module out of
the port.
v For SFP modules that contain wire tabs, grasp the wire latch and pull
the SFP module out of the minihub port.
d. Replace the protective cap on the SFP module.
e. Place the SFP module into a static-protective package.
f. Replace the protective cap on the port.
a. Push down on the latch (centered above the RAID controller). Pull both
levers at the same time out of the locked position.
b. Grasp the pull-rings (see Figure 87 on page 119), then pull on the levers
and remove the RAID controller.
SFP module
SFP