Locations And Functions Of Parts; Front Panel - Sony HD Super Motion HKCU1001 Quick Manual

Locations and Functions of Parts

Front Panel

1 Red tally indicator
5 CABLE ALARM indicators
a Red tally indicator
Lights in red when this unit receives a red tally signal.
When the CALL button on the video camera, the MSU-
900 series Master Setup Unit, the RCP-700/900 series
Remote Control Panel, etc. is pressed, this indicator will go
out if previously lit, and light up if previously off.
You can attach the supplied number plate here.
b Green tally indicator
Lights in green when this unit receives a green tally signal.
You can attach the supplied number plate here.
c MIC (microphone) switch
Press to turn the intercom microphone on and off.
d INTERCOM level control
Turn to adjust the input level of the intercom.
e CABLE ALARM indicators
SHORT (red): Lights in red if the power supply cord of
an optical fiber cable is short-circuited to its external
sheath, or if two power supply cords are short-
circuited. Power is not supplied to the camera when
this indicator is lit.
36
Locations and Functions of Parts
2 Green tally indicator
3 MIC switch
4 INTERCOM level control
1
8 INTERCOM connector
7 CAMERA switch and indicator
6 MAIN POWER switch and indicator
HD CAMERA CONTROL UNIT HDCU3300
OPEN (red): Lights in red when a camera is not connected
to the CAMERA connector on the rear panel of this
unit via an optical fiber cable.
Flashes when the connection status of an optical fiber
cable is bad.
f MAIN POWER switch and indicator
Turns the entire camera system on and off, including this
unit, the video camera, and the RCP-700/900 series
Remote Control Panel connected to the REMOTE
connector of this unit.
Press the "?" side to turn the camera system on, and the
"a" side to turn it off.
The indicator lights when the power switch is turned on.
g CAMERA switch and indicator
Turns the video camera on and off when the MAIN
POWER switch is turned on.
Press the "?" side to turn on the video camera and the "1"
side to turn it off.
When the CAM PW button of the remote control panel
connected to this unit is set to off, you can't turn on the
video camera with this switch only.