Locations And Functions Of Parts; Front Panel - Sony HXCU-D70 Operating Instructions Manual

Locations and Functions of Parts

Front Panel

a Tally light
Turns on red to indicate a red tally signal is being received
(such as when the picture from the camera connected to the
CCU is being used). When the CALL button on the camera or
the RCP-1000- series Remote Control Panel is pressed, the
light turns off if lit or turns on if not lit.
Turns on green to indicate a green tally signal is being
received.
A number plate supplied with the CCU can be attached here
(see the following figure).
b CABLE ALARM indicators
OPEN: Turns on when a camera is not connected (open
circuit) to the CAMERA connector on the rear panel via a
multi-core cable. While on, the CCU does not supply any
power to the camera.
It flashes when there is a problem with the transmission
between the camera and the CCU.
c INTERCOM audio input/output and control block
INTERCOM (intercom adjustment) knob
MIC/PGM (microphone/program) switch
INTERCOM (intercom select) switch
INTERCOM
MIC-ON PROD
OFF
PGM ENG
INTERCOM
connector
• INTERCOM (intercom adjustment) knob
Adjusts the receiver audio level of the intercom.
a b c d e f g h
CABLE INTERCOM
MENU
PANEL
ALARM
ACTIVE
OPEN MIC-ON PROD DISP CANCEL
OFF
CAM
POWER
PGM ENG MENU ENTER
POWER
LOCK
CONTROL
ON
CALL
OFF
NETWORK
l mn o pq
• MIC/PGM (microphone/program) switch
ON: Turns the headset microphone on.
OFF: Turns the headset microphone off.
PGM: Selects program audio output. In this mode, the
• INTERCOM (intercom select) switch
Selects the intercom signal input/output connection source for
the INTERCOM connector on the front panel.
PROD: Connects the producer line.
ENG: Connects the engineer line.
• INTERCOM connector (XLR 5-pin)
Connects the intercom headset.
For information on pin assignment, see "INTERCOM" in "Pin
assignment" on page 33.
d MENU control block
DISP/MENU (display/menu) lever and indicator
DISP
MENU
• DISP/MENU (display/menu) lever and indicator
Selects the status display or setup menu display. In setup
menu mode, the indicator turns on.
• CANCEL/ENTER lever
In setup menu mode, used to cancel and enter settings.
• CONTROL knob (rotary encoder)
In status screen mode, used to change the displayed page.
In setup menu mode, used to move the cursor on a page and
to change menu settings. Pressing the CONTROL knob
performs the same function as setting the CANCEL/ENTER
lever to the ENTER position.
i j
SHUTTER MASTER GAIN
ECS
SW1 SW2 BARS STANDARD
UP UP
ON
DOWN DOWN
CUSTOM ATW PRESET WHITE BLACK/FLARE MASTER BLACK
WHITE
AUTO
BLACK
HD CAMERA CONTROL UNIT HXCU-D70
s t
r
INTERCOM knob adjusts the headset program audio level.
CANCEL/ENTER lever
MENU
CANCEL
ENTER
CONTROL
CONTROL knob
Locations and Functions of Parts
k
ALARM
IRIS/MB
AUTO
ACTIVE
IRIS
EXT
u
9