Precautions In Disassembly And Reassembly Of Battery Charger - Hitachi RB 14DSL Technical Data And Service Manual

Reassembly can be accomplished by following the disassembly procedures in reverse. However, special
attention should be given to the following items.
1. Reassembly of the power supply unit
Perform wiring according to the wiring diagram.
Black
Motor Holder (A) [9]
2. Reassembly of others
Reassembly can be accomplished by following the above disassembly procedures in reverse.
Machine Screw M4 x 10 [5]------------------------------------------------------------ 1.4 to 2.2 N
Tapping Screws D3.5 [11] [15] [17] ------------------------------------------------- 1.3 to 1.9 N
Nut M6 [13] ------------------------------------------------------------------------------- 3.9 to 5.9 N

2. Precautions in disassembly and reassembly of battery charger

Refer to the Technical Data and Service Manual for precautions in disassembly and reassembly of the
battery charger Model UC 18YRSL.
Reassembly
Red
Red
Motor [8]
Screw tightening torque
-8-
DC-Trigger Switch [3]
Printed Circuit Board [2]
Black
Black
Red
Yellow
Battery Holder [4]
m (14 to 22 kgf
•
m (13 to 19 kgf
•
m (40 to 60 kgf
•
cm)
•
cm)
•
cm)
•