Table of Contents
Advertisement
Installation and Commissioning Manual
2.3.9 RS232 Interface
The FCPTEC-HS4200 & FCPTEC-HS-4400 are
equipped with an isolated RS232 I/F Circuit at the
bottom of the base card.
The terminal block connections are shown opposite.
TX = Transmit Data from the panel, RX = Receive
Data into the panel, GND = Ground Reference.
The RS232 I/F can be used with the RS232 I/F Cable
Kit. This kit consists of the cable and a bulkhead
mounting connector thereby enabling external
connection without opening the door.
The internal RS232 I/F Cable Kit option provides
connections, via a standard 9-way d-type connector,
from the outside of the enclosure.
To install the cable:
1. Remove the cover plate in the bottom face of the
back box.
2. Secure the D-Type Connector in the mounting hole
using the fixing hardware supplied.
3. Plug the end of the cable into the socket header on
the base card.
(Refer to the RS232 Interface Section above for details
of the terminal block signals).
The D-Type connector can be used with:
A PC Cable Kit to connect the panel directly to a PC.
A Modem and Cable Kit for remote PC connection.
A Printer Adapter and Cable Kits for connection to a
printer.
Contact your supplier for the relevant part numbers and
order information for option kits.
Document Reference
MTEC-HS-01
Rev
071
Author
ADV-DC
RS232
Base Card Connections - typical.
RS232 Cable &
Recommended Routing
Typical Internal Arrangement
Page
18
Advertisement
Table of Contents
