Zone Interface Function - Haes ESENTO MARINE Installation, Commissioning & Operating Manual

4 3 4 4
Conventional Sounder Circuit Functional Options
This option is used to programme each of the conventional sounder circuits on the main circuit board with
custom reponses as below.
Enter the above code and press ENTER. Then use button 1 to select the sounder
circuit to be programmed (indicated by a steady fire zone LED) as per table.
With the required sounder LED lit, press the ENTER button. Fire zone LED 1 will now
pulse. This indicates setting up function 1 (resets on silence alarms) for the selected
circuit. Use button 1 to scroll to the required function, indicated buy pulsing fire LEDs 1- 4 as per table
below.
Fire LED
LED 1
(pulsing)
Resets on
Function Silence
Alarms
Amber
fault LED
OFF
(default
setting)

ZONE INTERFACE FUNCTION

This is a special setting to configure the last zone on the panel, (i.e. zone 2 on the 2 zone or zone 4 on the
4 zone), to be used for interconnection from other control panels.
The function is enabled by setting switch 2 on the 3 way DIL switch located on the main PCB to the 'ON'
position.
With switch 1 in the 'ON' position, the last zone becomes;
1. Non latching
2. Non aux operating.
Example connection
Esento Marine 2-4 Installation, Commissioning & Operating Manual
LED 2 LED 3
Activates Activates
on on Class
Evacuate Change
ON OFF
ZONE2 ZONE3 ZONE4
+ - + - + -
PANEL 1
SETUP & PROGRAMMING
Use button 2 to change the response
LED 4
to ON or OFF, indicated by the amber
fault LEDs.
Activates
Then use button 1 again to scroll to
on Alert
the next function if required.
Press the ENTER button to return
OFF
back to sounder circuit selection,
indicated by a steady fire LED.
1 2
Approved Document UI-ESENMAR-01 Issue 6.0
23
LED 1 LED 2
SNDR1 SNDR2
(Main (Main
PCB) PCB)
3 4 5 6 7
ON
1 2 3
3K3
470
C NC NO C NC
NO
FAULT
FIRE
(optional)
PANEL 2