Features Setup Page - MATSONIC MS9147C Series User Manual

Features Setup Page

This page sets up some parameters for peripheral devices
connected to the system.
AMIBIOS SETUP – FEATURES SETUP
(C) 2000 American Megatrends, Inc. All Rights Reserved
OnBoard FDC
OnBoard Serial PortA
OnBoard Serial PortB
Serial Port2 Mode
OnBoard Parallel Port
Parallel Port Mode
Parallel Port IRQ
Parallel Port DMA
OnBoard Game Port
OnBoard MIDI Port
MIDI Port IRQ
OnBoard IDE
Audio Device
Modem Device
Ethernet Device
USB Controller
USB Device Legacy Support
ThumbDrive Support for DOS
Use this item to enable or disable the
OnBoard FDC
onboard floppy disk drive interface.
Use these items to enable or disable the
OnBoard Serial
onboard COM1/2 serial port, and to assign
PortA/B
a port address.
Use this item to enable or disable the
Onboard
onboard LPT1 parallel port, and to assign a
Parallel Port
port address. The Auto setting will detect
and available address.
Use this item to set the parallel port mode.
Parallel Port
You can select SPP (Standard Parallel
Mode
Port), ECP (Extended Capabilities Port),
EPP (Enhanced Parallel Port), or ECP +
EPP.
Use this item to assign IRQ to the parallel
Parallel Port
port.
IRQ
3: BIOS Setup Utility
Enabled
3F8h/COM1
2F8h/COM2
Normal
378h
SPP
7
N/A
ESC : Quit
201h
Item
300h
F1 : Help
10
Both
F5 : Old Values (Shift)F2 : Color
Enabled
F6 : Load BIOS Defaults
Auto
Enabled F7 : Load Setup Defaults
All USB Port
Disabled
Disabled
↑↓← → : Select
PU/PD/+/ - : Modify
35