Culligan Gold Series Installation & Operation Instructions page 60

Seal Pack Assembly
Follow the instructions for the replacing drive motor assembly through step 7, then continue as follows:
1. With the drive motor set aside, firmly pull the seal pack assembly from the valve body.
2. Lightly lubricate the o-rings of the replacement seal pack with silicone grease.
3. Reverse the procedure for reassembly.
Note: Use only silicone grease; petroleum-based lubricants will cause the degradation of the rubber components.
Caution! Do not twist the seal pack upon insertion. This can cause the outer o-rings to pinch, cut, or crimp.
Eductor Piston/Eductor Sleeve Assembly
Follow the instructions for the replacing drive motor assembly
through step 7, then continue as follows:
1. With the drive motor set aside, firmly pull the eductor piston
& sleeve assembly from the valve body.
2. Lightly lubricate the o-rings of the replacement piston &
sleeve assembly with silicone grease.
3. Reverse the procedure for reassembly.
Note: Use only silicone grease; petroleum-based lubricants
will cause the degradation of the rubber components.
Note: The eductor piston & sleeve assemblies are unique
to the softener, filter, and controls. Refer to the parts list to ensure that the proper assembly is used.
58 Culligan Gold Series ® Water Softener
Figure 24