Culligan Gold Series Installation & Operation Instructions page 19

Loading the Tank (12" and 14" Tanks)
1. Position the tank so that the Culligan
2. Remove the inlet strainer.
3. Install the outlet manifold into the tank (Figure 10).
4. Cover the tops of the manifolds with a clean rag.
5. Using a large-mouth funnel, load the Culligan underbedding through the top of the tank.
Caution! DO NOT allow the outlet manifold to move when loading the media.
The manifold must remain vertical to ensure a good seal at the gasket. Rap the
tank near the bottom with a rubber mallet to level the sand.
6. Aqua-Sensor Installation (optional
®
device)
A. Measure the sensor cable
length as shown in Figure 10
and Table 1 (the Aqua-Sensor
cord is set at the factory for a
9" tank).
B. Loosen the small Aqua-Sensor
Plug, a needle-nose pliers
works best.
C. Moisten the cable sheath and
slide the cable grip up or down
to the proper cable length.
D. Tighten the small Aqua-Sensor
plug so that the fitting cannot
slide along the cable.
Note: There must be no kinks or bends in the cable.
E. Insert the probe and cable through the Aqua-Sensor port.
7. Load the tank with the Cullex
the funnel.
8. Install the inlet strainer making sure to thread the strainer until it bottoms out on the
tank thread. Failure to install the strainer correctly can cause the control to leak.
logo is in the front.
®
Dimension "X" is the exposed length the Aqua-
Sensor cord (cord length from the Aqua-Sensor
®
plug to the circuit board connector). You can then
verify the Aqua-Sensor probe is inserted to the
proper depth by confirming dimension "X" is at the
corrected length.
Tank Model
9" Quadra-Hull Tank
™
10" Quadra-Hull Tank
12" Quadra-Hull Tank
14" Quadra-Hull Tank
Table 1
® ion exchange resin. Leveling is not required. Remove
X Y
34 1/2" 40"
30 1/2" 44"
32 1/2" 42"
22 1/2" 52"
Figure 10
Small
Aqua-Sensor
®
Plug
Figure 11
Installation 17