NOTE:
When re-assembling the paper eject actuator and the eject actuator spring to the FU frame
lower, ensure the paper eject actuator is seated correctly in the locating channel referring to
the figure below;
Paper eject actuator
(28) Disconnect the heater harness.
(29) Remove the four cup B M3x6 Taptite screws.
(30) Remove the four claw holder plate.
(31) Remove the four separate claw ASSY.
Claw holder plate
Separate claw ASSY
Heater harness
MFC-8420/8820D/8820DN, DCP-8020/8025D/8025DN
FU frame lower
Eject actuator spring
Fig. 4-109
Taptite, cup B M3x6
Fig. 4-110
4-61
SERVICE MANUAL
Separate claw ASSY
Tweezers