Akai S3000XL User Manual page 268

Stereo digital sampler
Table of Contents

Advertisement

GLOBAL
NOTE: In all the above selections, the
The soft keys on this page are:
Page 262
- This will cause the take to play back upon receipt of a
suitable MIDI note but with a delay offset set in the delay: field described
below. If
is pressed, however, playback is immediate in the PLAY
page.
- This will cause the take to playback when it receives a MIDI
SONG START command after
This sets the delay offset used for triggering a takes playback when
is selected in the
This allows you to set which MIDI note will cause the take to playback
when
or
This allows you to set the MIDI channel for the take. In this way, you can
set a specific MIDI channel for the MIDI triggering of takes.
This field allows you to set the playback level of the take.
This allows you to set the pan position of a mono recording or the left/right
balance of a stereo recording.
This sets the level of the signal that will be sent to the assignable
individual outputs.
This sets the destination of the take. The default is OFF but you may set
these to any outputs you want. You may also use this parameter to send
takes to the internal effects. The level at which they will appear at the
individual outputs or the effects is set in the
This takes you to the DD TAKES view page
This takes you the SONG mode where you may compile takes for
sequential playback or MIDI triggering
This takes you to the play pages where you may play takes
This takes you to the take editing display
Shows the currently active page
Takes you directly to the record page for recording new takes
Takes you to the BACK-UP SAVE page where you may archive takes to
DAT via the digital audio interface.
This primes the take for immediate playback from within this page
is pressed.
key must be pressed before a take is played.
field described above.
is selected.
S3000XL Operator's Manual
field.

Advertisement

Table of Contents
loading

Table of Contents