Table of Contents
Advertisement
EDIT SAMPLE
As with TRIM, the S3000XL is very considerate and won't let you ruin good loops and if
you move the start or end points into any loop zone (shown above the waveform) you will
receive the warnings:
or
In this case, whatever editing action you perform will be ignored.
As with Timestretch and Re-sampling, if you create a new sample from any of the above
editing procedures, the original loop points will be lost and you will need to reset them.
You may select to edit in mono or stereo accordingly. Of course, this only has relevance if
the sample is stereo in which case you may prefer to edit the left and right channels
separately.
IMPORTANT NOTE ABOUT SETTING START AND END POINTS: The start and end
points are temporary whilst in the sectional edit page They are not stored anywhere. If you
leave SECT or select another sample, these will be lost and you will have to set them
again.
S3000XL Operator's Manual
Page 153
Advertisement
Table of Contents
