Table of Contents
Advertisement
EQ
The S3000XL is also equipped with an EQ (equalisation) DSP function. This allows you to
add EQ, affecting the tone of the sample. Pressing
give this screen display:
In the EQ, you may select from four different EQ types and apply cut and boost of gain at
specific frequencies. The EQ is only one band but you may EQ samples that you have
already processed to have an almost unlimited amount of frequency bands!
The fields on this page are:
S3000XL Operator's Manual
Here you may select whether you will edit in mono or, with stereo samples,
in stereo. When EQ'ing stereo samples, you can select MONO and EQ
each side separately if you wish.
This selects the EQ response curve. You may select LOW SHELF. This
offers the following response slope:
A frequency range below the EQ frequency setting can be cut or boosted.
This is good for adding or removing bass end components in a sound.
The next selection is BAND WIDE:
A wide band either side of the EQ frequency can be cut or boosted. This
selection is useful for gently accentuating or removing certain frequencies
in the sound. It would be useful to add some mid range frequencies to a
snare sound, for example. The next selection, BAND THIN is well suited for
removing specific frequencies but the wider frequency response of BAND
WIDE makes the EQ effect slightly broader.
in any of the DSP pages will
FREQ
FREQ
EDIT SAMPLE
Page 145
Advertisement
Table of Contents
