Table of Contents
Advertisement
The signal available at these outputs is determined by the set up software :
The Setup software is an important part of the system because it allows for offline configuration of the MIX4
to fit it in almost every production environment from Edit Workstation to On Air. It serves for general
settings a user is not allowed to change from the desktop remote.
For remote control purposes the MIX4 is equipped with 8 tally outputs and 6 GPI inputs with TTL levels.
Their functions will be set by Setup software as well.
In addition, a TCP/IP over Ethernet interface allows the remote control of external routers via TCP/IP as well
as the centralized use of the setup software and the operator/preset/backup/restore tool over the
network.
There is also a serial interface for connection to a PC via RS 232 that serves for configuration of the MIX4.
This interface may also be used in RS 422 mode.
232
422
remote connector
Firmware updates and the initial IP configuration are only possible via RS232 interface.
Ethernet
TCP/ IP
serial
CAN bus
power
page
Jünger Audio-Studiotechnik GmbH
6 x GPI
8 x Tally
audio sync
optional
video sync
5
WC out
sync in
Advertisement
Table of Contents
