Mix4 Principle Functions - junger MIX4 Operation Manual

The Junger MIX4 is a Digital Audio Mixer with 4 stereo full-featured Channel Strips.
The MX4 has 4 independent stereo mix busses, each of which can be independently configured :
Mix The Bus works as an ordinary stereo mix bus
Mix Minus Actually the same as a Mix config, but you don't route one or more Strips to it.
PreMix The bus is used as a prefade Aux send.
PostMix The bus is used as a postfade Aux send.
Direct Out A prefade send from one and only one strip is routed to the bus.
Level Controls marked
are controlled with the
Strip's Rotary Knob
Channel Strip Input
Each of the 4 Channel Strips of the MIX4 can be connected to one of the 14 inputs (sources).
Sources 1 and 2 are normally used for microphones but can be used for analog line level signals.
All other inputs are two channel sources and therefore they can carry two channel and stereo signals as well.
The settings of each Channel Strip are controlled and stored to the relating source it is connected to.
The bus outputs are available in both analog and AES digital.
Please see the block diagram below :
A / D
A / D
on board
4 AES / EBU
inputs with
sample rate
converters
IF slot 1
2 MIC
4 AES/EBU I/O
8 analog in
8 MADI Ch. I/O
8 SDI Ch. I/O
IF slot 2
2 MIC
4 AES/EBU I/O
8 analog in
8 MADI Ch. I/O
8 SDI Ch. I/O
Each bus has a distortion free "brick wall limiter" with Look Ahead feature to catch all peaks.

MIX4 Principle Functions

Prefade Aux
Send Level
*
Strip
Fader
*
Offset Channel
Gain Gain
Level Control Simple Diagram
gain / phase / filter / EQ
dynamic processing
gain / phase / filter / EQ
dynamic processing
gain / phase / filter / EQ
dynamic processing
gain / phase / filter / EQ
dynamic processing
source
parameter for
selection
processing
page
Prefade Aux Out
*
Postfade Aux
Send Level
Postfade Aux Out
*
Mix and Mix Minus Out
Direct Out
Ch A
Ch B
Ch C
Ch D
mix matrix
filter and multiplier
dynamic coefficients
3
Jünger Audio-Studiotechnik GmbH
mix matrix including
channel selection and
multiplier
Bus
Limiter 1
Bus
Limiter 2
Bus
Limiter 3
Bus
Limiter 4