Table of Contents
Advertisement
Individual functions can be assigned to most buttons of the MIX4 remote control which often maybe bound
up with Tally functions (see Tally page).
User Buttons pane
The 4 User Buttons can have these functions :
Source Monitor
Talk to Hybrid
Monitor LL
Monitor RR
Output x Off
Mon-Split BUSx
Event
Important note! The Event function is not implemented for external trigger via GPI!
Bus Buttons pane
The Bus Buttons have Bus Monitor and Event (indicated green) functions only for now.
Meter follows pane
The LED level indicator on the console can be set to look at any one of these 5 options:
Follow Monitor
Bus 1
Bus 2
Bus 3
Bus 4
Meter Reference Point pane
The Meter Reference Point can be selected between :
0 dBFS
Limiter Setting
PFL pane
Auto PFL in Source Selection Mode
Mute Monitor Line Output pane
The Monitor Speaker output can be muted under either or both conditions: When ON AIR/When Mic opened
Desktop-Unit Setup
assign a source for monitoring purpose (no meter, no offset gain)
enables an independent way to talk directly to a telephone
sends the left monitor signal to both speakers
sends the right monitor signal to both speakers
turns the related physical bus outputs off
splits the monitor signal in BUSx (right channel) and PFL (left channel)
can have Event trigger function with 3 different colors (green, red, yellow)
PFL and BUS will be shown on the meters but not any sources
meters bus 1
meters bus 2
meters bus 3
meters bus 4
The setting for the limiter is used for the full scale meter reading.
That is, if the limiter is set for -6 dBFS, then the top LED on the
meters equals -6 dBFS.
turns PFL automatically on when selecting sources
on a channel strip
page
33
Jünger Audio-Studiotechnik GmbH
Advertisement
Table of Contents
