Table of Contents
Advertisement
10.2 The selection screen below shows up :
10.3 Here one must select the DHD output that is connected with that MIX4 input.
It is a good practice to name these tie lines in a way one could easy choose them from this list. The
naming is done by aid of the DHD Toolbox (go to the item "DSP frame I/O").
Also we would recommend to set up each tie line as a stereo signal (see MIX4_MON label above).
Stereo Lines can be detected by the leading hex number 2 (0x2yyy).
Important Note! As already mentioned in the <Monitor> Setup chapter : Both the "Router" and the
"Disabled" check boxes must be 'checked' in Setup software for monitor only purpose. This will
automatically prevent that tie line from being assigned to a Channel Strip.
10.4 Finally you must send the source set up "to Device".
page
51
Jünger Audio-Studiotechnik GmbH
Advertisement
Table of Contents
