Connect To Phone/Fxs Interface - Quintum Tenor AX Product Manual

Chapter 3: Installation/Basic Troubleshooting

Connect to Phone/FXS Interface

For the AXT4800 product only, the Phone/FXS port interface has FXO capability, and is
NOTE:
labeled "LINE/FXO (1-24)".
Since there are many different PBX devices, key systems, fax machines and phones you can connect
to the Tenor AX, the instructions which follow explain the general procedure for connecting an
external device to the Phone/FXS port through the 50-pin Telco connector. Use the phone/FXS ports
for on-premise wiring only.
A double ended Telco cable connects to PBXs or phone systems that are equipped with the appropri-
ate 50-pin Telco interface. An un-terminated cable can be used with a break out box or another type
of termination device specific to your needs. See
connector pinouts you can use to acquire another cable or adaptor that may be required to connect to
the specific external device (i.e., PBX).
50 Pin Telco Connector
Break Out Box
Connect to Phone/FXS port as follows:
CAUTION: Connect the Phone/FXS ports to a telephone, fax machine, PBX or key system only.
Connecting to other devices/networks (i.e., telephone wall jack) will cause damage to
the unit.
The instructions below assume you are using a double ended 50-pin Telco cable. See
Hardware Components
1. Plug one end of the 50-pin Telco cable into the port labeled Phone/FXS.
3-6
VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299
Figure 3-4 Connect to Phone/FXS port
OR
Telephone
Fax
for pinout information.
Chapter 2: Hardware Components
PBX
PBX
for the 50-pin
Chapter 2:
P/N 480-0062-00-14