Transaxle (10052) - Better Outdoor Products Quick Series Operator's Manual

3. Using a 7/16 wrench, remove the starter cable
Figure 76.
Figure 76
4. Disconnect throttle cable (refer to Throttle/Choke
Cable Replacement).
5. Turn gas tank valve to Off position Figure 77.
Figure 77
6. Using a straight screwdriver, disconnect fuel line
from engine Figure 78.
Figure 78
7. Remove transaxle drive belt (refer to Transaxle
Drive Belt).
37
8. Remove clutch (refer to Clutch Replacement).
9. Using a ½ wrench and ½ socket, remove the
10. Lift engine slowly while turning it so the muffler
11. Install new engine in reverse order.

Transaxle (10052)

1. Remove belt guard cover (refer to Belt Guard
2. Disconnect the interlock switch wiring at brake
3. Disconnect the operator presence cable at
4. Disconnect the forward cable at transaxle (refer
5. Disconnect the reverse cable at clutch (refer to
6. Disconnect the blade engagement cable (refer
7. Remove the transaxle drive belt (refer to
8. Remove rear wheels (refer to Rear Wheel).
9. Using a ½ wrench and a ½ socket, remove the
10. Using a ½ wrench and socket, remove transaxle
Note: It is recommended to have another person to
help remove the old transaxle and to install the new
one.
11. Remove transaxle by pulling it toward the front
12. Install the new transaxle in reverse order being
BetterOutdoorProducts.com
four bolts holding the engine to the power unit.
clears heat shield (if equipped).
Cover).
arm (refer to Transaxle Interlock Switch).
transaxle (refer to Operator Presence Cable).
to Forward Drive Cable).
Reverse Cable).
to Blade Engagement).
Transaxle Drive Belt).
7" tail strut bolt located at the rear of the
transaxle (refer to Battery Replacement).
mounting bolts Figure 79.
Figure 79
of machine until the bypass arm clears the
opening in the frame.
careful not to damage the transaxle fill cap.