Forward Cable(10425); Reverse Cable (10525); Operator Presence/Parking Brake Cable (10609); Handle Bar Height - Better Outdoor Products Quick Series Operator's Manual

Forward Cable(10425)

After several hours of operation the drive cables will set
at a longer length. Cables may need re-adjustment to
obtain maximum forward/reverse speed.
1. Locate the forward drive cable adjuster by
following cable from drive control to adjuster
Figure 11.
Adjusters
2. Turn the center barrel clockwise for less forward
speed, counter-clockwise for more forward
speed.
Note: Reverse cable may also need adjustment
to remove any free-play in control handles.
Note: When properly adjusted, the
forward/reverse levers should have 1/8" play.

Reverse Cable (10525)

1. Locate the reverse drive cable adjuster by
following cable from the reverse control to
adjuster see Figure 11 above.
2. Turn the center barrel clockwise for less reverse
speed, counter-clockwise for more reverse
speed.
Note: Forward cable may also need adjustment
to remove any free-play in control handles.
Note: When properly adjusted, the
forward/reverse levers should have 1/8" play.
Operator Presence/Parking Brake Cable
(10609)
1. Locate the operator presence cable adjuster
by following cable down from handle.
Figure 11
BetterOutdoorProducts.com
17
2. Turn the center barrel clockwise to remove
excess free-play Figure 12.
Note: When properly adjusted, the operator
presence/brake lever should have 1/8" play.

Handle Bar Height

There are two settings.
Lower holes are for normal operation.
Top holes are for taller people or Step Saver users.
1. Using a 9/16 wrench, remove both bolts holding
each side of the handle bars to the power unit
Figure 13.
2. Move handle bars to desired location and
reinstall bolts.
Figure 12
Figure 13