Repair; Ignition Switch; Transaxle Interlock Switch (10185); Brake Interlock Switch (10092) - Better Outdoor Products Quick Series Operator's Manual

Before replacing any part, ALWAYS remove battery
ground cables and insulate terminals.

Ignition Switch

Electric Start (10286)
Manual Start (10333)
1. Remove ignition key.
2. Using a 7/8 open end wrench, remove the nylon
ignition switch nut (10501).
3. Reach under dash panel and pull ignition switch
out Figure 27.
4. Unplug ignition switch from wiring harness.
5. Install new switch in reverse order.

Transaxle Interlock Switch (10185)

1. Unplug harness from interlock switch Figure 28.
Figure 27
Figure 28
BetterOutdoorProducts.com
25

Repair

2. Using a ½ wrench and a ½ socket, remove both
bolts holding interlock bracket to transaxle
Figure 29.
3. Using a 3/8 and 5/16 wrench, remove interlock
switch from bracket.
4. Install new switch in reverse order.
Note: Make sure there is a small gap between
the interlock switch button and hydro arm. This
can be checked by using a .010 feeler gage
Figure 28.

Brake Interlock Switch (10092)

1. Using two 17mm wrenches, loosen brake arm
bolt Figure 30.
2. Unplug harness from interlock switch.
3. Squeeze tabs and remove switch.
4. Install new switch in reverse order.
Figure 29
Figure 30