Operator Presence/Brake Cable (10609) Handle (10206); Blade Engagement Control Cable (10081) - Better Outdoor Products Quick Series Operator's Manual

Operator Presence/Brake Cable (10609)
Handle (10206)
1. Using a 13mm wrench, loosen the jam nut
Figure 47.
2. Remove both socket head screws from the
operator presence handle (10206) Figure 47.
5
3. Cut cable ties.
4. Pull brake arm located under the lower right
hand side of machine Figure 48.
7
5. Detach the T-barb from the handle Figure 47.
6. Unscrew the cable from the handle.
7. Remove the hairpin cotter and washer Figure
48.
8. With a pair of pliers, collapse both tabs and
carefully remove cable.
9. Install new cable in reverse order, making sure
to seat both rubber boots on each end of cable.
Note: Adjust cable so there is 1/8" free-play in
handle Figure 49.
2
1
Figure 47
4
Figure 48
BetterOutdoorProducts.com
30

Blade Engagement Control Cable (10081)

1. Disconnect the wiring plug from the safety
switch under the PTO control Figure 50.
2. Remove PTO knob by turning counter
clockwise.
3. Using a 3/8 wrench, remove the 4 mounting
screws Figure 51.
Figure 49
Figure 50
3
Figure 51