Rear Wheel; Front Caster Wheel (10007); Engine - Better Outdoor Products Quick Series Operator's Manual

6. Replace spring and install in reverse order.
Note: Grease idler arm after reinstalling.

Rear Wheel

1. Support the rear of machine securely with a jack
stand (making sure not to rest on the transaxle
lever) so the wheels are off the ground Figure
73.
2. Using a straight screwdriver, remove the E clips
Figure 74.
Figure 72
Figure 73
Figure 74
BetterOutdoorProducts.com
36
3. Remove rear wheels, spacers (10065), and
drive keys (10064).
4. Install new wheel in reverse order.
Note: Be sure wheel drive keys are in place.
All Models except
Super Fox
Super Fox

Front Caster Wheel (10007)

1. Using two 1-1/8 wrenches, remove axle bolt and
remove wheel.
2. Install in reverse order. Note: When reinstalling
axle bolt place a small amount of (Blue)
Loctite™ on threads. Make sure wheel turns
freely. Do not over tighten. Also, grease wheel
bearings.

Engine

1. Remove battery if equipped (refer to Battery
Replacement).
2. Disconnect wiring harness from rear of engine
Figure 75.
Figure 75