Quick™ Adjustments; Height Of Cut - Better Outdoor Products Quick Series Operator's Manual

Height of Cut

1. Support front of deck with a jack stand Figure 7.
2. Remove lynch pin (10006) from the top of caster
fork Figure 8.
3. Remove HOC spacers (10004) and slide caster
fork out Figure 9.
Quick™ Adjustments
Figure 7
Figure 8
BetterOutdoorProducts.com
16
4. Add/remove spacers to the bottom side of the
fork for desired height of cut. See table below.
5. Install in reverse order and repeat on other fork.
6. Using a ¾ socket, loosen the nut 1 ½ to 2 full
turns for the rear height of cut adjustment on
both sides Figure 10.
7. Pull up or push down on the rear of the deck to
align the arrow on the rear adjusters so that they
both point to the number position that matches
your caster fork setting and retighten nuts.
8. The height-of-cut can be adjusted from 1 to 4
inch (25 to 100 mm).
Note: Machines leave the factory set at 21/2".
Grass Height
1 inch
1 ½ inches
2 inches
2 ½ inches
3 inches
3 ½ inches
4 inches
Figure 9
Figure 10
Front Casters Rear Adjustment
0 spacers
1 spacer
2 spacers
3 spacers
4 spacers
5 spacers
6 spacers
0
1
2
3
4
5
6