Installation/Removing The; Removing The Unit - Kenwood KIV-700 Instruction Manual

Installation/Removing the Unit
Installation
Bend the tabs of the mounting
sleeve with a screwdriver or similar
utensil and attach it in place.
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
¤
CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal part such as
the heat sink and enclosure become hot.
70
|
KIV-700
Removing the hard rubber frame
1
2
⁄
• The frame can be removed from the bottom side in the

Removing the Unit

1
2
3
¤
• Be careful to avoid injury from the catch pins on the
4
Autogood products Internet store "130"
Engage the catch pins on the removal tool and
remove the two locks on the upper level.
Lift up and pull the frame forward as shown in the
figure.
Accessory 2
Removal tool
When the upper level is removed, remove the
lower two locations.
same manner.
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
Insert the two removal tools deeply into the slots
on each side, as shown.
Lower the removal tool toward the bottom, and
pull out the unit halfway while pressing towards
the inside.
removal tool.
Pull the unit all the way out with your hands, being
careful not to drop it.
Lock
Catch
Accessory 2