Accessories/ Installation - Kenwood KIV-700 Instruction Manual

Accessories/ Installation Procedure
Accessories
1
..........1
2
..........2
Installation Procedure
1
To prevent short circuits, remove the key from the
ignition and disconnect the - terminal of the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the wire on the wiring harness.
4
Take Connector B on the wiring harness and
connect it to the speaker connector in your vehicle.
5
Take Connector A on the wiring harness and
connect it to the external power connector on your
vehicle.
6
Connect the wiring harness connector to the unit.
7
Install the unit in your car.
8
Reconnect the - terminal of the battery.
9
While pressing the [Volume] knob and the [MENU]
button, press the [SRC] button for at least 3
seconds. See <How to reset your unit> (page 3).
¤
• Mounting and wiring this product requires skills and
experience. For safety's sake, leave the mounting and wiring
work to professionals.
• Make sure to ground the unit to a negative 12V DC power
supply.
• Do not install the unit in a spot exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too
much dust or the possibility of water splashing.
• Do not use your own screws. Use only the screws provided.
If you use the wrong screws, you could damage the unit.
• If the power is not turned ON ("Protect" is displayed), the
speaker wire may have a short-circuit or touched the
chassis of the vehicle and the protection function may
have been activated. Therefore, the speaker wire should be
checked.
• Make sure that all wire connections are securely made by
inserting jacks until they lock completely.
• If your vehicle's ignition does not have an ACC position, or
if the ignition wire is connected to a power source with
constant voltage such as a battery wire, the power will not
3
..........1
2 m
4
..........1
2.5 m
Autogood products Internet store "130"
be linked with the ignition (i.e., it will not turn on and off
along with the ignition). If you want to link the unit's power
with the ignition, connect the ignition wire to a power
source that can be turned on and off with the ignition key.
• Use a commercially available conversion connector if the
connector does not fit in the vehicle connector.
• Insulate unconnected wires with vinyl tape or other similar
material. To prevent a short circuit, do not remove the caps
on the ends of the unconnected wires or the terminals.
• If the fuse blows, first make sure the wires aren't touching
to cause a short circuit, then replace the old fuse with one
with the same rating.
• Connect the speaker wires correctly to the terminals to
which they correspond. The unit may be damaged or fail to
work if you share the - wires or ground them to any metal
part in the car.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
About CD players/disc changers connected
to this unit
If the CD player/ disc changer has the "O-N" switch, set
it to the "N" position.
The functions you can use and the information that
can be displayed may differ depending on the models
being connected.
67
|
English